Insignia NS-HTMC01-B Power Button Replacement

ID: 78950

Description: This guide will help you replace a broken or...

Steps:

  1. Flip your device over so the bottom panel faces you. You should see a hole containing a screw in each corner of the device.
  2. Insert a 4-inch Phillips #1 screwdriver into each hole until connected with the 20 millimeter, sharp-point screw.
    3. Step image
  3. Find the power switch, located inside the heater on the bottom left corner.
    4. Step image
  4. Using a Phillips #1 screwdriver, unscrew the two 7 millimeter screws attaching the power switch to the power button.
    5. Step image
  5. Find the clips holding the power button in place.
  6. Press down on the clips to remove the button.
    7. Step image Step image
Back