ACN Iris WG4K Blade Connector Replacement

ID: 87853

Description: The blade connector helps transmit power from...

Steps:

  1. Press upwards with your index finger on the 4P4C connector as shown in the image.
  2. Pull the connector gently out of its socket.
    3. Step image Step image
  3. Flip the main body of the video phone so that the bottom is facing up.
  4. Use the Phillips #0 Screwdriver to remove the four Phillips head screws (6 mm) highlighted by the red circles.
    5. Step image
  5. Lift the back case upwards to expose the inside components.
  6. Red rectangles indicate the three ribbon cables.
  7. The orange square indicates the blade connector.
    8. Step image Step image
  8. Disconnect the three ribbon cables from their insulation-displacement connectors by flipping up the black plastic clip.
  9. Gently pull the ribbon cables out of their insulation-displacement connectors.
    10. Step image Step image Step image
  10. Disconnect the blade connector from the blade receptacle by gripping the exposed area of the blade connector.
  11. Gently pull the blade connector out of the blade receptacle.
    12. Step image Step image
  12. Gently lift up the lower case to separate it from the top case.
    13. Step image
  13. Use the Phillips #0 Screwdriver to remove the four Phillips head screws (6 mm) highlighted by the red circles.
    14. Step image
  14. Gently lift up on the upper case to separate it from the keypad/speaker panel.
    15. Step image
  15. Use the Phillips #0 Screwdriver to remove the two Phillips head screws (5 mm) located on the upper case.
    16. Step image
  16. Rotate the top case 180 degrees so that the video screen is closest to you.
  17. Lift up the bottom up so that it is perpendicular to the table (this helps you reach the two top screws).
  18. The four Phillips head screws (6 mm) are highlighted by the red circles.
    19. Step image
  19. Use the Phillips #0 Screwdriver to remove the four Phillips head screws (6 mm).
    20. Step image
  20. Flip the top case so that the video screen is facing up.
    21. Step image
  21. Rotate the top case 180 degrees.
  22. Gently lift up on the video screen and the blade and ribbon connector to give you more slack to work with.
    23. Step image
  23. Place the video screen face down to expose the two screws. The screws are indicated by the red circles.
    24. Step image
  24. Use the Phillips #0 Screwdriver to remove the two Phillips head screws (6 mm)
    25. Step image Step image
  25. Pull the ribbon connector and blade connector through the top case.
    26. Step image Step image
Back