Vornado Duo Circuit Board Replacement

ID: 99077

Description: In this replacement guide, step by step...

Steps:

1. Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device.

2. Carefully take front panel off.

3. Loosen 5 mm screw at bottom of fan blade located inside the blades.

4. Remove fan blade after unscrewing top 2 screws located on each side of the covered board.

5. Remove cover from board.

6. Unsolder the circled spots on the mother board and resolder each wire to corresponding spot.