D-Link HD Wi-Fi Camera LED Lights Replacement

ID: 99231

Description: This guide will show how to take apart a D-Link...

Steps:

  1. Place the camera upwards between your thumb and first finger.
  2. Tilt the camera to the best position and loosen the captive linings using a plastic opening tool.
  3. Slide the top cover outwards to separate the upper section from the lower lid using the plastic opening tool.
    4. Step image
  4. Remove the 6.0mm Phillips #00 screws that secure the back cover to the inner frame.
  5. Lift the rear lid upwards using your fingers and separate it from the internal components and motherboard.
    6. Step image Step image
  6. Unscrew the motherboard from the frame. There are 3 Phillips #00 5.0mm screws holding it in place.
  7. Then (gently!) remove the motherboard and the lens with your fingers.
    8. Step image Step image
  8. To remove the front cover, place index finger in the center and pull away from the frame. This may take a little effort, but should not require an opening tool.
    9. Step image
  9. After the cover is removed, unscrew the two Phillips #00 5.0mm screws. Then the board should slide right out.
    10. Step image Step image
  10. There are two lights, one on either side of the board.
    11. Step image
Back