Ninja Coffee Bar CF080 Control Panel Replacement

ID: 99246

Description: This guide will show how to remove the control...

Steps:

1. Face the machine bottom towards you.

2. Unscrew six 0.6cm screws by holding the bottom board with Torx #10 screwdriver to remove the board.
3. Unscrew one 0.6 cm screw with PH1 screwdriver to remove the board.

4. With moderate force remove and place the "plastic opening tool" between the divide in order to remove the bottom board.

5. Remove the bottom board with moderate force.

6. Unscrew eight 0.6cm sized screws with Phillips #1 screwdriver, holding the silver secures on the sides of the heated plate.
7. Four screws on each side, two silver secures to remove the securers, located on the sliver bar holding the heated plate (one on each end).

8. Unscrew two 0.6cm sized screws Phillips #1 screwdriver.
9. The silver bar will fall off once screws are removed.

10. Remove the heated plate from the machine with easy glide.

11. Remove the nine 0.5cm screws with Phillips #2 screwdriver.
12. Some screws are harder to see due to how deep the holes are.
13. Recommend using Extender 4 with Phillips #2 screwdriver to help unscrew the screws within the deep holes of the machine.

14. Remove the two 0.6cm with Phillips #2 screwdriver.

15. Detach various colored cords from one another, using both hands to place thumb and index finger to hold each grip then separate by pulling with the degree of force.
16. There with be 1 blue, 1 black, 1 red and 2 white.

17. Remove the black board by maneuvering it through the cords.

18. Grip the bottom end of the panel and pull it towards you to remove the module from the machine.

19. Remove the three 0.6cm screws with Phillips #1 screwdriver.
20. They are in the black holes, 1 at the top and two at the bottom.

21. Remove the black board attached to the module.

22. Unscrew four 1.2cm screws with Phillips #2 screwdriver.

23. Carefully remove the control panel from the control module.

24. Left with the control module.