Xbox One Wireless Controller 1697 Bumpers Replacement

ID: 99256

Description: Bumpers on an Xbox One Wireless Controller 1697...

Steps:

1. Remove the battery pack cover.
2. Remove the two AA batteries.
3. Carefully remove the sticker or puncture to reveal the screw.

4. Remove the side handles by wedging the spudger around the side panels.
5. Pry the side panel by moving the spudger back and forth. You must do this along the entire seam to remove the side handle panel.
6. There are seven clips that need to be opened to remove each handle panel.

7. Removing the side handles allows access to remove the faceplate.
8. Use the TORX TR8 screwdriver to remove the five TR9 Torx screws.

9. Now that the bumpers are easily visible make sure to clean any dirt or grime that may be around the bumpers.
10. The bumpers are connected by a middle plastic cover that is around the Xbox home button. Remove this plastic piece by lifting the plastic cover over the two pins, pressing the home button in, and pushing the cover towards the top of the controller.
11. Be aware of the sync button loosely placed under the plastic covering. Ensure it is put back before putting back the bumper/plastic cover assembly.
12. Remove the current bumper assembly by pulling them off the plastic cover.

13. The controller is now ready for the new bumper assembly.
14. Align the new bumpers onto the top of the controller by holding down the triggers and aligning the four pins on both sides.
15. Set the new home button cover over the micro USB port, push the home button in, and pull the cover over the two pins shown.