Apalus Digital Hair Straightening Brush Heating Element Replacement

ID: 100562

Description: Use this guide if you need to replace the...

Steps:

1. Remove the seven 5mm Phillips #1 screws on the comb-side of the brush.

2. Turn comb over so the bristles are facing down.
3. Remove backside of the comb and place aside.

4. Unplug the power cord from the connector inside of the brush.

5. Remove the circuit board and heating element from the handle.
6. This will provide easy access to the necessary components.

7. Remove the four 6mm Phillips #2 screws holding the heat shield onto the back side of the bristles.

8. There are 4 solder points of the heating element located on the LCD side of the circuit board.
9. Desolder these four connections using a soldering iron.
10. Note which wires go to each of the connection points.
11. Soldering Technique Guide

12. Solder the new heating element to the same connection points as they were removed from.