Netgear Arlo Plastic Housing Replacement

ID: 103261

Description: How to remove the plastic housing of the camera...

Steps:

1. Locate unlock switch on underside of camera and unlock it by sliding it.
2. Once unlocked, slide the cover out and up to open the battery housing.

3. Remove all 4 of the 3.0 Volt batteries from the battery housing.

4. Inspect prongs at the bottom of the battery housing to ensure that they are not bent or broken before replacing the batteries.

5. Remove the 2 (3.5mm) housing screws with a J0 screwdriver.

6. Slide the unlocked battery cover forward to remove 2 (3.5mm) screws, that are behind the cover.

7. Open the battery cover and remove the 2 (3.5mm") screws from under the cover.

8. Use a plastic opening tool to start separating the plastic housing from the front side of the battery cover.
9. Next, start separating the plastic cover from the rear of the plastic housing, and work your way down the seam line.
10. Make sure the plastics snaps on the front of the plastic get unhooked from the grey plastic ring around the front of the camera.

11. Remove the screw (3.5mm) near the sync button holding the opposite side of the camera on.
12. Remove the second screw (3.5mm) on the back of the camera to remove the second housing.
13. Once the screws are removed use an opening tool to pry back the second plastic mount.