Zoomer Show Pony Speaker Replacement

ID: 105158

Description: This guide is an extension of the volume slider...

Steps:

1. Flip the pony over.
2. Remove the five Triangle 3 screws from underneath.
3. The pony will separate into a few pieces once the screws are removed.

4. Disconnect all of the wires between the head and leg sections.
5. To replace the power/volume switch, remove the two Phillips #0 screws from the switch.
6. Lift the switch out to replace.

7. Remove the black bar by unscrewing the two triangle screws marked in yellow. These screws are recessed into the black bar so you may need an extender for your triangle bit.

8. If you are not replacing the pony's speaker, skip the next bullet point.
9. Lift out the speaker, again making sure that it is disconnected, and replace with a new one.