Pyle Astro PTBL7C Power Button Replacement

ID: 106863

Description: The Pyle Astro's power button is a simple push...

Steps:

  1. Using the plastic opening tool, work your way along the edge of the tablet.
  2. The display is held in place by plastic tabs which slide into recesses in the rear plastic panel.
  3. Once all clips are released, gently open and separate the front display assembly and the rear plastic panel.
  4. Place the front display assembly facing front side down to expose the inside.
    5. Step image Step image
  5. Remove the three 4 mm JIS #0 screws to release the PCB board.
    6. Step image Step image
  6. Flip the PCB board upside down to expose the solder joints for the power button.
  7. Gently de-solder the four solder joints of the push button switch (power button).
  8. How To Solder and Desolder Connections Guide
    9. Step image
  9. Install the new push button switch and solder all the connections back into place.
  10. How To Solder and Desolder Connections Guide
    11. Step image
Back