Keurig 2.0-400 LCD Screen Replacement

ID: 108490

Description: In this guide, you will replace the LCD screen....

Steps:

1. Open the K-Cup Chamber Housing Lid by lifting up the silver handle below the LCD screen.
2. This is the part of the brewer you open to place a K-Cup inside.

3. Place the Keurig on its side.
4. Remove the two 140mm screws located on the underside of the Chamber Lid using the Phillips #1 screwdriver.
5. Remove the top black housing that surrounds the screen.

6. Using the Phillips #1 screwdriver, remove the two 140mm screws connecting the silver handle to the top of the Keurig.

7. Pull out the front silver handle from the top of the brewer.
8. This will further expose the LCD screen.

9. Using the metal spudger, pry open the snaps holding the LCD screen panel to the brewer, just enough for the panel to pop loose.
10. Warning: These snaps are very delicate and can easily be broken. Practice caution as you perform this step.

11. Remove the top black housing by lifting it up.
12. This will expose the frame of the Keurig connecting to the LCD screen.

13. Remove the black latch with the black wire connecting the front end of the panel to the frame.
14. The front end of the panel will now be free.

15. On the bottom of the panel, remove the white tab that connects the wires of the circuit board to the LCD screen
16. To remove the tab, squeeze in on the sides of it as you pull it out.
17. Remove the touch screen panel from your device.