HP ProBook 450 G4 Keyboard Replacement

ID: 130575

Description: If your HP ProBook 450 G4 keyboard is being...

Steps:

1. Power your laptop off.
2. Flip the laptop over.
3. Orient the laptop so the two vents on the bottom face upward and are further away from you.

4. Use the Phillips #0 screwdriver to remove the 6.8 mm screw that secures the vent panel to the laptop.
5. Use the spudger to separate the vent panel from the laptop.
6. Slide the vent panel off the backside of the laptop.

7. Use the Phillips #0 screwdriver to remove the black 3.2mm screw that secures the hard drive to the left side of the laptop.

8. Use the spudger to lift the left side of the hard drive up.
9. Pull the hard drive diagonally to the left to release the hard drive from the laptop.

10. Remove the 6.6mm T8 Torx screw located below where the hard drive used to be.
11. Remove the 6.6mm T8 Torx screw located below and to the left of the circular, silver and black fan.

12. Use the spudger to press down on the two black tabs that are underneath where the hard drive used to be.
13. Apply pressure to the black tabs until they release and pop out.

14. Orient the laptop so the keyboard is facing upwards and towards you.
15. Insert the spudger in between the edge of the keyboard and the computer frame.
16. Slide the spudger around the edge of the keyboard until the keyboard is loose.
17. Gently pull the keyboard away from the body of the laptop.
18. Do not pull the keyboard all the way off because there is still a connector cable underneath that needs to be disconnected.

19. Use a spudger to gently lift up the black locking bar on the keyboard connector.
20. Slide the keyboard ribbon out of the connector.
21. Remove the keyboard.
22. To re-attach the keyboard ribbon, slide it into the connector and swing the locking bar down.