Bosch arriva 1500 W Disassembly

ID: 135832

Description: You may want to open it up to clean out the...

Steps:

1. Remove the top cap, and any filters.

2. There is only one screw to remove, at the back of the vacuum cleaner.
3. Put the screw in a safe place

4. Use a screwdriver to unclip the body of the motor. There are two clips in front and one on the side of the plug (towards the back).

5. Remove the top of the body of the motor.

6. Remove the on/off button.

7. Slide the electric plug coil out of its rails.
8. For reassembling, see step 10.

9. Slide the electric circuit board out of the electric plug coil.

10. Lift out the motor.
11. Gently unwrap the fleece.

12. The motor is held in place by two rubber pieces on either side.
13. You may remove these rubber parts from the motor

14. Re-assemble in reverse order until step 6.
15. Slide the plug coil into its rails. Make sure that the coil is completely wrapped up around the wheel. Otherwise the spring in the wheel may be totally loose, and will not coil.
16. Carefully put the button into its hole. It should stick out over the little curved groove, over the wires. Check that it turns the dimmer and clicks the on-off push button.