Yoga Tab 3 Pro Battery Replacement

ID: 142432

Description: To complete this guide you'll need a Philips #0...

Steps:

  1. Flip the tablet with the rear panel facing up.
  2. Push the central button to lift the support.
  3. Open the support entirely, using your hands.
  4. Remember to turn off the device before doing any repair.
    5. Step image Step image Step image
  5. You'll need to remove the adesive on the back plate before removing the screws.
  6. Remove the sticker using the plastic spudger by lifting it up from one side, then you can remove it entirely by using your fingers.
  7. Use the Philips #0 screwriver to remove the three screws.
    8. Step image Step image Step image
  8. Divide the two halfs by inserting the spudger in the gap between the front shell and the rear one. To help you out with this job you can also use some guitar picks.
  9. Do the same procedure on all three visible sides, including the two round side parts.
  10. Be careful not to insert the spudger too deep into the device, to not damage the internal component.
  11. You could use a little bit of force since the half is also hooked in the central portion on the tablet.
  12. Important: the rear shell is the one that you remove from the front one; the internal component including the display, will stay attached to the front panel.
    13. Step image Step image Step image
  13. Once you unhook all the internal clips you can easily remove the rear panel.
  14. Watch out at the two side keys and at the central one, since they'll detach form the rear shell. and You'll need to put them back during the reassembly.
    15. Step image Step image Step image
  15. Remove the two screws that hold the plate for the battery connector, by using a Philips #00 screwdriver.
  16. Remove the plate by using tweezers.
    17. Step image Step image
  17. Use the flat portion of a spudger to unplug the battery from the motherboard.
  18. Pull the connector away from the motherboard.
    19. Step image Step image
  19. Use the tweezers to lift up the adhesive pull tabs.
  20. Use your fingers to lift up the adhesive pull tabs to
  21. Insert translation here
  22. Insert translation here
    23. Step image Step image Step image
  23. Do the same procedure on the second adhesive pull tabs to remove it entirely.
  24. If the adhesive pull tabs broke try to recover it by using flat point tweezers or your fingers.
  25. Never force the battery and don't pierce it. Doing so can cause leak of liquid chemical or flame.
    26. Step image
  26. If one or both the adhesive pull tabs break, you can use a small amount of isopropyl alcol ( in a solution concentrated > 90%)
  27. Insert the alcool near the adhesive pull tabs and let it
  28. Insert translation here
  29. Insert translation here
    30. Step image
  30. Now that you've completely removed the double-sided tape, you can remove the battery very easily.
    31. Step image
Back