GOTRAX GMAX Ultra Brake Caliper Replacement

ID: 147639

Description: Brakes are some of the most important...

Steps:

1. Use the 5mm hex key to remove the 16mm screw holding the brake cable in place.
2. This will release the brake cable and metal clamp.

3. Next, use the 4 mm Hex key to remove the 14 mm screw on the side of the caliper that holds the housing to the brake pads.
4. As soon as the screw is loosened, a spring will release the tension of the caliper.

5. Use the 4 mm Hex key to remove two 22 mm screws that hold the caliper to the scooter body.
6. Carefully remove these to avoid scratching the wheel cover with the hex key.

7. With the two screws removed, the caliper is now free from the scooter.
8. Loosen the screw and washer that holds the brake cable in place.

9. This screw and washer stays on the scooter so it only needs to be loosened enough to free the cable.
10. No tools are required to loosen this, but you can always use something like pliers if it was screwed too tight.

11. Remove the brake caliper.