Honeywell Turbo Force Air Circulator Fan Disassembly

ID: 149120

Description: This guide will show you how to disassemble a...

Steps:

1. Honeywell Turbo Force 12" Air Circulator.
2. Dimensions - 11.22" x 9.8" x 13.98", 5.7 lbs.

3. Remove the 6 screws from the backside of the fan.
4. You will want a Phillips screwdriver with a fairly long, thin shaft for this step, especially for the screw up top above the fan speed knob. The screws are recessed several inches into the body of the fan.

5. Remove the front grill cover.

6. Remove the inside plastic ring around center shaft.
7. Enables the fan blades to be removed.
8. Use a flat head screwdriver to remove the plastic ring.
9. During reassembly, you will likely need to apply pressure on two opposite sides of the ring in order for it to re-mount to the post properly. Ensure that the raised convex side is facing towards you.

10. Remove the fan blades by pulling.

11. Remove 1 screw inside to detach the plastic wire covering.

12. Remove the plastic covering.

13. Remove the 2 screws on the motor.
14. This allows the motor to pull away from the housing.

15. Pull the motor away from the housing to expose wiring.
16. Use caution to not detach the wiring from the back.

17. Remove the two screws from the back of the motor.
18. Allows the rotor and front/back bearings to be removed.

19. Remove the rotor and front bearings by pulling.

20. During reassembly, re-align the bearings by tapping on the shaft.