Honeywell HT900C Motor Replacement

ID: 155311

Description: There are a number of potential causes if your...

Steps:

1. Remove the six 15 mm screws securing the fan's frame to its outer ring on the back using a Phillips #1 screwdriver.
2. Due to the small size of the screw holes, a long and thin screwdriver may be necessary.

3. To gain access to the fan's inner workings, gently pull the blade cover away from the main body.

4. Remove the two 36 mm screws from the metal plate located behind the blades using a Phillips #1 screwdriver.
5. The screws can be hard to remove so you may need to twist the screwdriver harder and screws can be removed easily.

6. Carefully pull the motor it out of its resting position and tilt it forward to access the back of the motor.

7. Remove two 10 mm screws from the motor's back using a Phillips #1 screwdriver.

8. Remove the 20 mm screws beside the fan blade using a Phillips #1 screwdriver.
9. The screws are attached to two parts of the motor so it can easily fall off after removing the screws.

10. Carefully remove the circular motor from the square holder.
11. The circular motor is still connected to the fan blades.

12. Remove the metal washer from the axle.

13. Replace the old motor with a new one, and you're done!
14. Using the lubricant to easily put the new motor back.
15. Always double-check that the screws are securely in place.