GameSir T4 Pro Joystick Replacement

ID: 155546

Description: If your joystick has broken over time, this...

Steps:

  1. Using the Phillips 1 screwdriver, gently turn the screw to the left (repeat this step until all four screws are taken out).
    2. Step image
  2. Use your iFixit opening tool to break the seam of the back of your controller.
  3. Be careful when pulling apart, as the charging port wires are connected to both sides of the controller.
    4. Step image
  4. Using the plastic spudger, wiggle the connection out of place.
    5. Step image
  5. Apply a slow, but consistent pull to the old 600 maH battery.
  6. Attach new battery onto the pad.
    7. Step image
  7. Disconnect the rumblers from the motherboard
  8. Be careful not to pull the wires while disconnecting rumbler
    9. Step image Step image
  9. Using the screwdriver, remove the 5 mm screws from the motherboard
    10. Step image
  10. Using the wedge tool, pop the joystick out
    11. Step image Step image
  11. Make sure the square of the joystick matches the square of the pad and pop it in place.
    12. Step image Step image
Back