GameSir T4 Pro Charging Port Replacement

ID: 155547

Description: Use this guide to replace the charging port of...

Steps:

1. Using the Phillips 1 screwdriver, gently turn the screw to the left (repeat this step until all four screws are taken out).

2. Use your iFixit opening tool to break the seam of the back of your controller.
3. Be careful when pulling apart, as the charging port wires are connected to both sides of the controller.

4. Using the plastic spudger, wiggle the connection out of place.

5. Apply a slow, but consistent pull to the old 600 maH battery.
6. Attach new battery onto the pad.

7. Use the needle nose pliers to remove the plastic connection from the motherboard.
8. You may hold the wires for stability, but do not tug on the wires.

9. Remove the two 5mm screws on the charging port and take out the old charging port.

10. Put your new compatible charging port in place.
11. Make sure to screw in the 5mm screws into your new charing port