Commercial 8 Quart Bowl-Lift Stand Mixer - Switch Guard Replacement

ID: 157971

Description: The switch guard is there to prevent accidental...

Steps:

1. Before starting ANY repair/disassembly of the mixer, make sure it is fully unplugged from the electrical outlet.
2. If this mixer is being used in a commercial environment, a LOTO tag can be affixed via the hole on one of the prongs on the mains plug to prevent accidental activation.
3. Using a #2 Philips Screwdriver, remove the screw which holds on the trim band.
4. Remove the trim band.

5. Remove the four screws (circled in yellow, two on each side) using a #2 Philips Screwdriver
6. Remove the motor housing by lifting it straight up.

7. Using a #2 Phillips screwdriver, remove the single screw attaching the switch guard to the mixer body.
8. The second image shows the rough location of the screw, while the third image shows an unobstructed view of said screw.