AVerMedia NEXUS AX310 Teardown

ID: 158827

Description: Its pretty expensive device to mix\stream audio...

Steps:

1. Remove rubbers (red). They are pretty dense so to not worry to damage them. Do not remove label (blue) - it have hole under, but it is not a screw hole

2. Remove 6 PH1 screws. Need to notice, that upper 3 screws are deep - so you need long thin screwdriver.

3. Unclick latches using long side of credit card. I recomend this because latches are really strong and not flexible, so this wat to do this will help to keep them alive
4. You need to do this above rgb line
5. Do both sides and bottom, after that upper side will free itself.
6. Do not pull upper half of streamer as it connected to bottom with wires

7. Lift bottom side and make colorful wire visible and acceseble
8. Unplug it. This part do not have any clips, so gust push it down

9. Flip bottom half of streamer more and make display and touchscreen plumes visible
10. Remove black isolation (if you have it) on bottom pcb
11. Lift black lockers
12. Remove plumes

13. Remove 6 PH1 screws on top
14. Im done on this, because my goal was to check any marks on screen. I think to fully remove top pcb you need to remove bottom parts of audio spinnerы but i cannot do it