Simjack Pro Replace Brass bushing by Bearing

ID: 163151

Description: This is a quick tutorial on how to replace the...

Steps:

1. There's no spring on the brake pedal.
2. Just pull it with your finger, pretty easy to remove.

3. Just unscrew both M6 screw using the 5mm Allen Key.
4. If one screw is jammed and make the whole thing turn, just re-tight the other one and try again. Should be fine after that.

5. Just push or pull the middle tube then push the bushing out.

6. Add the bearing into the hole flange facing "outside".
7. Add a M5 1mm washing on the bearing, on the flanged part (facing outside).
8. 1mm washer is important.
9. You may use a dot of grease to keep the washer from falling.

10. Add the M5 bolt with a washer on it,
11. Make sure the washer on the bearing is still there, it's very important. You can use a flat screw driver to help you push it at the right place.
12. The internal and external washer dosent need to be precise 1mm. Only the one in the "middle".

13. Add the washer and a M5 Nylon nuts.
14. You will have to push the bolt back a little to fit the nut.

15. Tight everything, very tight.
16. Nothing should be moving, except the pedals on the bearing. If it's not moving, maybe your bearing is not 1mm or it has fallen.
17. You may see a little "play" from the bearing into the metal plate, but it was minimal for me. You could add some glue to force it still into place.

18. Only for clutch and gas pedals.
19. Just place the spring back into place. You may use a little flat screw driver for help.