Razor Hovertrax 2.0 Charging Port Replacement

ID: 167306

Description: Use this guide to replace a damaged or broken...

Steps:

1. Use a #2 Philips screwdriver to remove the eight 18.5 mm screws from the bottom of the Hovertrax 2.0.

2. To remove the led connector from the board, press the clip in with your fingers and gently pull up.
3. The connector you are removing is black and has two pins.
4. If it does not want to come out, gently wiggle the connector side to side while pulling up.

5. Disconnect the battery connector by grabbing the black side with one hand and the yellow side with the other hand and gently pull apart. (Try not to pull on the wires, it could damage them)
6. If you are replacing other parts, leave the battery disconnected until the end.

7. Remove the two 17.2 mm hex head bolts using the 4 mm hex screwdriver that secures the battery in place.

8. The battery should be able to be lifted up out of the device now.

9. Use a #2 Phillips Screwdriver to remove the circled screws.

10. Remove the black shell with the warning stickers.
11. Be cautious of the two wires attached to the circuit board when lifting the shell
12. Carefully disconnect the two connectors from the circuit board.
13. The two connectors you are disconnecting are black and have two pins.

14. Remove the hot glue covering the charging port
15. Our team was able to remove the hot glue by peeling is off with our fingers.
16. Use your fingertips to remove the nut.