HP 15-dy2024nr Trackpad Replacement

ID: 171100

Description: This guide will show you how to replace the...

Steps:

1. Use a spudger to peel one corner of each of the rubber feet from the bottom of the laptop.
2. Gently peel the feet from the laptop using the spudger revealing the screws underneath.
3. If the rubber foot peels away but leaves adhesive behind you must peel the adhesive away before removing the screws.

4. Use a Phillips #1 screwdriver to remove:
5. Two 2.5mm x 6mm screws
6. Six 2mm x 6mm screws
7. Be sure to keep different screw sizes separated.

8. Insert an iFixit opening tool into the seam between the keyboard area and bottom cover.
9. Using another iFixit opening tool, slide along the seam to unhook the clips.
10. There are clips all the way around the seam. You may hear a popping sound as the clips come loose. This step may require some force to separate the back cover from the laptop.
11. When the front of the laptop is open, you can use your finger to hold a corner open then slide an iFixit opening tool along the seam toward the back corner.
12. After the clips have been released, flip the laptop over and lift the cover.

13. Remove five 2.0mm x 3.0mm screws using a Phillips #00 screwdriver.
14. Use the iFixit opening picks to lift the battery away from the laptop.

15. Be aware that the battery is plugged into the motherboard.
16. Unplug the battery from the motherboard.
17. Lift the battery away from the laptop and remove.

18. Remove two 3.0 mm screws using a Phillips #1 screwdriver.
19. Lift the metal bracket away from the laptop and remove it with your hands.

20. Remove three 2.0 mm screws using a Phillips #0 screwdriver.

21. Lift the track pad away from the laptop and remove with your hands.