JBL Tune 510BT Power Button Replacement

ID: 171117

Description: Before using this guide, look at the JBL Tune...

Steps:

1. Firmly grasp the earmuff and pull away from the center until the lip of the earmuff is disengaged.
2. Pull the earmuff towards the center of the headphones until it is free.

3. Remove the three 3 mm screws using a JIS #00 screwdriver.

4. Carefully remove the faceplate by lifting it firmly.
5. Avoid rough movements, as there is a single thin wire connecting the faceplate to the internals.
6. If the repair is for the right-side driver, be mindful of the charging port, as the faceplate has a slot there for it. Lift the opposite end and back the port out.
7. To completely detach the faceplate, desolder the wires from the connections on the motherboard.

8. Remove the 1 mm screw using a JIS #00 screwdriver.
9. Using your finger or a Jimmy, gently pry the circuit board from the casing, being careful to not pull too hard to dislodge the connected wires.

10. Gently push the damaged power button from the outside towards the inner part of the headphone casing until it dislodges.
11. Replace it with the new button by connecting the tabs at the top and swinging the button into place.