Nanit Pro N301 Speaker Replacement

ID: 171916

Description: If your Nanit Pro N301 is not producing any...

Steps:

1. Insert an opening pick into the seam between the front and rear case.
2. Slide the opening pick around the perimeter of the camera until all of the retaining clips are released.
3. Separate the front and rear case.

4. Remove the four 4 mm T6 Torx screws from each corner of the circuit board.
5. Lift the circuit board out of the chassis.

6. Remove the two screws that secure the speaker with a T3 Torx screwdriver.

7. Use tweezers to disconnect the speaker motherboard connection.
8. Do not pull on the wires.
9. Remove the speaker.