Bose Soundlink Flex Radiator Replacement

ID: 172013

Description: The radiator on the Bose Soundlink Flex is what...

Steps:

1. Use a heat gun to warm up the device.
2. This will allow for an easier removal of the grille and prevent damage to the device during the replacement. If you do not have access to a heat gun, a hair dryer works as well.

3. Use an iFixit opening tool to pop off the eight clips on the grille.
4. Be patient and do not rush this process as you may otherwise damage the device.

5. Once the clips have been released, the only thing holding the grille on is glue.
6. Apply minimal force and the grille should pop right off the device.
7. Reheat the device to warm up the glue if there is difficulty in removing.

8. Remove the four 2.3 mm screws holding the driver in place using a TR8 Torx screwdriver.
9. Lift the driver out, being cautious of the wires still connected to the device.

10. Remove the six 2.3 mm screws around the edge with a TR8 Torx screwdriver.

11. Pull the backplate off to expose both sides of the radiator.

12. Remove the four 2.3 mm corner screws using a TR8 Torx screwdriver.
13. Remove the two 1.7 mm screws using a TR6 Torx screwdriver.
14. Follow this step for both radiators.

15. Remove the radiator and replace with the new radiator.