Samsung Older French Door Refrigerator Inverter Board Replacement

ID: 177960

Description: Use this guide to replace the inverter board on...

Steps:

1. Unplug your refrigerator before you begin your repair.
2. If you are testing or repairing the following items, you may also need to shut off and disconnect the water supply:
3. Condenser fan motor
4. Compressor motor and thermal overload device
5. Water supply valve assembly

6. Use a #2 Phillips driver to remove the screws securing the control board cover.

7. Grasp the cover at the upper edge and tilt the upper edge toward you.
8. Lift the lower edge off of the tabs at the bottom and remove the cover.

9. Locate the inverter board connectors in the red rectangles.

10. Disconnect each connector by squeezing the locking tab and pulling it straight out from the board.
11. Repeat this for each of the connectors.
12. One connector is shown as an example.

13. Locate the lock tab.

14. Lift the locking tab to release the inverter board.
15. Pull the top edge of the board outward toward you.

16. Remove the inverter board by pulling the top edge further toward you and lifting the board upward to free it from the lower retaining tabs.