Anbernic RG 40XXV Speaker Replacement

ID: 185474

Description: The speaker of your Anbernic RG 40XXV produces...

Steps:

1. Remove the micro SD card located on the left and right sides of the device by pushing into the SD card slot and pulling the card out.
2. Unscrew all six 7.5 mm screws on the backside of the case using a 1.5 mm hex screwdriver.

3. Take apart the case by separating the front and back sides using an iFixit opening tool.
4. When using the opening tool, carefully pry open the case to avoid damaging the device.

5. Disconnect the battery connection cable by gently pulling it away with angled tweezers from the slot that connects the cable to the motherboard.
6. The cable connection to the motherboard is labeled "+BAT-" for easy identification.

7. Using a Phillips #00 screwdriver, remove the 10 5.5 mm screws securing the circuit board to the case.

8. Remove the tape covering the ribbon cables.
9. Using ESD-safe tweezers, gently pull the ribbon cables away from the circuit board.
10. Using ESD-safe tweezers will prevent further damage to your device and harm to yourself.

11. Gently lift the circuit board out of the case.

12. Using ESD-safe tweezers, gently pull the speaker out of the case.
13. Using ESD-safe tweezers will prevent further damage to your device or harm to yourself.