Razer Tartarus V2 Keycap Stabilizers Replacement

ID: 185540

Description: The keycap stabilizers on the Razer Tartarus...

Steps:

1. Turn the keypad upside down.

2. Gently peel off the rubber feet with a Jimmy.
3. Set the rubber grip pads aside so you can reapply them later.
4. Use a Phillips #0 screwdriver to remove the following screws:
5. Twelve 6.4 mm-long screws
6. Two 3.7 mm-long screws

7. Peel up the bottom left corner of the largest sticker.
8. Remove the 6.4 mm-long Phillips #0 screw.

9. Carefully lift the joystick module up and out.
10. Separate the top and bottom casing of the keypad.
11. Use an Opening tool to pry the case open along the edges if necessary.

12. Locate the two rubber stabilizers:
13. One large stabilizer is positioned under keys 1–19.
14. One small stabilizer is under key 20.
15. Carefully pull each stabilizer up by hand from its respective board (motherboard or daughterboard)
16. Avoid applying excessive force or using sharp tools to prevent scratching or damaging the boards beneath the stabilizers.