Doss E-GO II Speaker Driver Replacement

ID: 186079

Description: Use this guide to replace the speaker driver in...

Steps:

1. Peel the backing off of the speaker.
2. Remove eight 7.9 mm screws using the Phillips #00 screwdriver.
3. Gently pull apart the grille on the sides of the speaker.

4. Remove four 9.6 mm screws from one of the speaker drivers using the Phillips #00 screwdriver.
5. Gently flip the driver up away from you.
6. Apply a bead of flux. Press the soldering iron tip firmly to melt the solder.
7. If you heat the area for more than 10 seconds, the excessive heat may damage the wires.
8. Repeat for the other speaker driver if needed.