Teenage Engineering OP-1 Connector Board Replacement

ID: 19125

Description: Use this guide to replace the Connector Board...

Steps:

1. Open the back panel by using a Jimmy on the side of the panel. Be careful not to damage the OP-1 coating.
2. Lift the back panel and remove it. The Connector Board is revealed.

3. Disconnect the flex connector by lifting it up with a spudger.
4. Remove the three Phillips screws. Do not lose the washer at the bottom screw.
5. Take out the connector board.
6. Make sure to keep the black rubber pad underneath the board.

7. Don't forget the cover for the on/off switch.
8. Simply take it off from the old board and transfer it to the new board.