Framework Laptop 16 Webcam Module Installation

ID: 194930

Description: Use this guide to replace the webcam, aka " lap...

Steps:

1. If your replacement webcam comes with liners covering the lenses, remove them now.
2. Place the webcam into its spot above the display, making sure the cable slides into its socket.

3. Use the flat end of your Framework Screwdriver, or a clean fingernail, to press down the locking tab on the webcam ZIF connector.

4. Use your fingers to place the washers into their spots on the Top Cover.
5. The washers only fit one way. If they're aren't fitting properly, flip them over.

6. While supporting the screen with one hand, use your Framework Screwdriver to install the two 2.0 mm‑long T5 Torx screws securing the webcam.