Razer DeathAdder V3 Pro Macro Buttons Replacement

ID: 200260

Description: If your Razer DeathAdder V3 Pro's macro buttons...

Steps:

1. Use a pry tool or fingernail to carefully remove the large foot on the lower end of the mouse.
2. Remove the three 7 mm screws using a Torx T6 screwdriver.

3. BEFORE YOU OPEN THE MOUSE: Be careful at this point. Both shells are connected with a cable in the front of the mouse.
4. Insert a spudger into the seam between the top and bottom shells.
5. Gently work around the edges unclipping the internal latches.
6. Slowly lift the top shell but do not remove it yet; the cables are still attached to the circuit board.
7. Carefully pull the shells apart to unplug the cable in the front.

8. Using a small pry tool or your fingers, gently pop the scroll wheel up and out of its housing

9. Unplug the ribbon cable connected to the side macro buttons from its raised position on the left.
10. Remove the macro buttons.

11. Use a spudger to remove the solder covering the switch, then pop off the faulty switch.
12. Apply flux, then use a soldering iron to heat the old solder.
13. Make sure to solder in a well-ventilated area.
14. Clean off the melted solder.

15. Apply flux to the removal sites of the switches.
16. Solder the new switches into the areas where the original switches were removed.