Nokia 225 4G 2020 Camera Replacement

ID: 213374

Description: If you are experiencing issues with the camera...

Insert an iFixit opening pick into the seam along the bottom edge of the phone’s back cover.
Slide the pick around the edges of the cover to release the retaining clips.
Remove the back casing to expose the battery.

Remove the battery by lifting it from the edge near the microSD card slot.
Install the battery, ensuring the metal contacts align with the connector at the bottom right of the compartment.

Use a T3 Torx screwdriver to remove the six screws along the edge of the bottom cover.

Insert an iFixit opening tool into the seam between the display and midframe and slide it around the edges to release the retaining clips.
Hold the device on both sides, then separate the display and the midframe to expose the motherboard.
Remove the motherboard.

Place a spudger or an opening tool under the edge of the camera connector and pry straight up to disconnect it.
Make sure to pry under the edge of the connector itself, and not under the socket on the board. Otherwise, you risk permanently damaging the socket.
Work carefully: don't pry on or accidentally scrape any small, surface mounted components on the board.
To reconnect, align the connector carefully over its socket and press down with your fingertip—first on one of the short sides, then the other—until it clicks into place. Don't try to force the connector into place. If you're having trouble, reposition it and try again.

Use a nylon spudger to pry the camera from the motherboard.
The camera is glued to the motherboard, so if you have trouble removing it, refer to the How to Use iFixit Adhesive Remover guide.
Metal spudgers and similar prying tools can cause damage. Choose a tool that's ESD-safe to avoid accidental damage to the device.

Back