Razer Wolverine V3 Pro Outer Shell Replacement

ID: 213614

Description: This guide shows how to remove the outer shell...

Steps:

1. Insert the end of a spudger or opening tool in the seam at the top of the controller.
2. Slide it around the edge to release the retaining clips.
3. Use the spudger to separate the front and back plastic outer shell of the controller.
4. Both panels should separate from the front of the bumpers.
5. This takes some patience to ensure the panels don’t crack.
6. Flip the controller so the bottom is facing up.
7. Use the spudger to separate the plastic covering on the hand grips.

8. Use a JIS #0 screwdriver to remove ten 10 mm screws from the mid-frame.
9. Keep screws organized.

10. Use your hands to pry the back panel of the controller.
11. You now have access to the back buttons (2 on each side).

12. Remove the two JIS #0 scews securing the battery.

13. Lift the actuators out of the way to access the screws beneath.
14. Use a Phillips #0 screwdriver to remove the two 6.9 mm screws under the voice coil actuators.

15. Remove the face cover from the controller.
16. The buttons may fall out in the process of removing the face cover. Be careful to not to lose them.
17. Now you have access to the internal components of the controller.