Campbell Hausfeld FP204800 Shroud Disassembly

ID: 31835

Description: Removing the shroud of the compressor can be...

Steps:

1. Unscrew the four 1cm long shroud screws using a 6mm Allen Wrench.

2. Remove the plastic shroud from the compressor.
3. Do not pull the shroud too far from the compressor. You could damage the on/off switch wiring.

4. Gently pull the wire attached from the pressure switch to the on/off switch.
5. It should come off the pressure switch with ease.
6. Make sure you are pulling the correct wire. The pressure switch could be in a different configuration on your compressor than in the picture.

7. Gently pull the wire connected from the on/off switch to the motor of the compressor.
8. It should be the only wire keeping the shroud from being lifted from the compressor.