How to Install a Fifth String Shubb Banjo Capo

ID: 37665

Description: Use basic skills and handy work to install a...

Steps:

1. Line the capo up along the fifth string side of the fretboard as shown.
2. Line the capo screw holes up about 12 mm from the fifth fret bar and about 4 mm from the face of the fret.
3. Be careful not to line the capo screw holes up directly below a fret bar or directly on top of a fret marker.

4. Use the marker to mark where the screws should go.

5. Use the drill to drill both holes for the two screws.
6. The holes should be drilled about 1 cm deep
7. You may need to borrow an extra pair of hands to help you stabilize the banjo while you perform this step.

8. Use the flat head screw driver to insert and tighten the screws.

9. To use the capo, slide the capo finger down to the desired fret.
10. Then, tighten the spring knob.