Black and Decker TO1303SB, TO1313B Top Cover Replacement

ID: 52215

Description: In order to complete the other repairs, except...

Steps:

  1. Remove the six 9.5mm screws on the back panel using a #2 Phillips screwdriver.
    2. Step image Step image
  2. Remove the two 13mm screws, located between the feet on the bottom of the cover, using a Torx T15 screw driver.
  3. On the TO1313SB, a Security Torx T15 driver is required — the screws have a center pin that prevents use of a regular T15 driver.
    4. Step image
  4. Using the metal spudger, carefully pry out the rubber base on each foot to access the screws.
    5. Step image
  5. Remove the 11.5 mm screws using a #2 Phillips screwdriver.
    6. Step image
  6. Remove the back cover by gently pulling the sides of the cover apart from the rest of the oven. Then, tilt the cover towards the face and pull back at an upward angle. The cover should slide right off.
    7. Step image Step image
Back