Samsung Captivate Camera Assembly Replacement

ID: 6821

Description: The camera assembly is susceptible to various...

Steps:

1. Remove the back cover by pressing on the bottom section of the phone and sliding the bottom piece downward.
2. Lift up the back cover.

3. Place your finger on the bottom of the battery and lift to remove.

4. Replace the old battery with the new one.

5. Insert the spudger underneath the bottom section of the phone.
6. Gently lift and push the spudger to slide the bottom section down to reveal two hidden screws.

7. Remove the six 4.5mm #000 Phillips screws.

8. Starting at a bottom corner, use the spudger to separate the rear case from the front display.
9. Move the spudger towards the top on both sides. The plastic opening tool is easier to use for this step.
10. Be careful when detaching the top. Free each side, stopping short of the center of the cover. Apply backward pressure on both corners with a finger applying pressure on the center, and slide the whole back cover toward the bottom of the device. Note: forcing the cover can result in cracked plastic.

11. Separate the rear case from the phone.

12. Use the spudger tool to pry up the chip labeled "NEC." This releases the chip.

13. Gently lift the camera assembly out of the plastic housing.