Harman Kardon Onyx Studio 2 Circuit Board Replacement

ID: 78750

Description: If you have looked at the troubleshooting page...

Steps:

1. Using a plastic opening tool, pry off the front grill by wedging it in the notch on the front of the device.

2. Remove the five 14.4 mm T10 Torx screws.

3. Gently pull the front apart from the back.

4. Remove the four wires connecting the front and back panels.
5. Pinch the connector tab and pull gently upwards.
6. Repeat for the other three connectors.

7. Pull the silicone button band off of the outer edge of the speaker.

8. Disconnect the two pressure connections from the circuit board.

9. Gently remove the control board band by placing fingers in contact with it through the button openings.
10. Work from the outer edges in so as not to bend the band.

11. Disconnect the remaining connectors from the circuit board.
12. Disconnect the Bluetooth antenna.

13. Remove the four 10 mm T10 Torx screws.
14. Pull the circuit board out of the device as it is now free.